Basics Basics Software supported crossover development The aim of this article is to consider the mode of operation, the far-reaching possibilities and, ultimately, the reliability of software-supported crossover development. Only the use of the computer as virtual crossover is considered. No housing simulation, no frequency simulation according to data sheets, TSP or any other parameters that are not based on real measurements on the object ⇒ All relevant ... Basics more Diagonal chamfers It has been extensively investigated how steep chamfers must be in order to function effectively. Modification of the tweeter Monacor DT-300, according to Klang & Ton 6 / 14 In the modification, the ferrofluid is removed, introduced into the pole core bore insulation wool and glued a felt ring on the pole plate. About baffle design, edge diffraction, secondary sound sources, ... ... and their influence on the sound quality of loudspeakers. adapter plate In order to connect different tweeters from the distribution of Tymphany and Scan-Speak cleanly with a waveguide (WG-300 from Monacor and P-Audio Horn-300) was created after many test series in a CNC machined adapter plate. Variable crossover with wagos Anyone who has ever tried to develop a loudspeaker, certainly knows the tiresome problem of the so often necessary change of components in the development diverter. Whether it is the Lustererklemmenvariante that works reliably but quite laboriously, or the annoying Krokoklemmengeschichte, which allows a simple change of components, but unfortunately a) A wild bunch of crossover and cable mix causes and b) one not before just pleasant surprises, so you solves the finally determined switch and nachmisst ... The result deviates usually significantly from target. Here I present you my version of the variable development switch. Cost around 15 €. Duration of assembly about 15 minutes.